Before Getting Started

  • Iron on light setting and increase the temperature if needed!!
  • Separate embroidery floss into three strands.
  • See Stitch guide & Getting Started section for more info.

Kit Details

  • Stitches used: Back Stitch, and Seed Stitch
  • Colors: DMC 907, 905, and Ecru

Stitch Details

Lt Green DMC 907 is used to back stitch leaf outlines, veins. Dk Green DMC 905 are single seed stitches on leaves. Fill in The center leaf shapes with rows of backstitch.

DMC Ecru is used on the flower pot pattern. Seed stitch for the dotted pattern on two flowers. Backstitch for everything else.

Be sure to secure your thread on the back by running your needle under existing stitches when first starting a new piece of floss and when you are ending a piece. It is important to do this behind a printed area so that you can cut out any stray threads that would show through the white fabric from the front. You should also do this if you need to move from one leaf to the next and your floss will show from the front. This will allow you to cut the floss in between the leaves so it will not be seen from the front and the floss won’t come loose. Another solution I have seen some folks use is to add a layer of white fabric behind the pre printed fabric to make the image more opaque.

1 of 4